Copper-Indium-Gallium-diSelenide (CIGS) thin film solar cell is a promising candidate for energy harvesting because of its high absorption coefficient and low cost compared to silicon-based solar cells. Absorber layer bandgap grading is a suitable method to improve CIGS thin film solar cell performance. Bandgap grading leads to a decrease in the recombination rate at the rear surface, which increases the open circuit voltage. Furthermore, bandgap grading improves the short circuit current due to the enhancement of collection probability. This paper introduces various routes for improving the performance of thin film CIGS solar cells by using bandgap grading. As a first step, both the bandgap energy and the thickness of the CIGS absorber layer of a uniform bandgap profile are optimized to get the best performance. Simulation is performed using SCAPS software and optimization results show that CIGS absorber layer with a bandgap of 1.2 eV and a thickness of 0.7 μm achieves a 22.48% efficiency. Then, bandgap grading with a parabolic distribution of various profiles is investigated and compared. It is found that with a parabolic double bandgap grading profile, which is a combination of front and back grading, an efficiency of up to 24.16% is achieved. This improvement is obtained using a gallium composition ratio of 0.1 for the minimal bandgap at 0.1 μm and 0.13 μm from the back contact and front contact, respectively. This result represents a 7.47% improvement compared to the baseline structure of a CIGS solar cell. |
